usi CSL2700 Owner's Manual page 14

allow the old film to run to a point just before it pulls off the cardboard cores.turn the drive switch to "oFF."
cut the film web with a blade so that approximately 5" of film extends beyond the idler bar. Photo 14-1.
CAUTION: When using a sharp object to cut film (blade or shears), avoid contact with heat shoes or rubber rollers.
remove the old cardboard cores and replace with new rolls of film. Photo 14-2.
loosen the tension on the top film roll. thread the new web of film around the idler bar and tape it to the remaining
segment of the expended roll. Photo 14-3.
repeat this procedure for the bottom film roll. Use caution when threading film near hot heat shoe .
run film through the laminator until the new web of film clears the pull rollers. Photo 14-4. readjust tension.
this laminator is equipped with an automatic Shut-off timer (aSt). If the drive motor is not activated for a period of 4
hours, the aSt will turn off the power to the machine. to power the machine up after it has been timed out, momentarily
press the drive switch to the on position. the aSt will reset and after appropriate heat-up time, the machine will be fully
operable. (You will also need to reset the drive switch upon turning on the machine for the first time of each day)
the aSt works in conjunction with the drive motor. Each time the drive motor is turned on, the aSt resets, therefore, the aSt
will not shut the machine down while you are in the middle of operating it, only when it is inactive.
rEloadInG a nEW roll oF FIlm
on a Hot lamInator
Photo 14-1
Photo 14-3
aUtomatIc SHUt-oFF tImEr
Photo 14-2
Photo 14-4
14