List Of Operating Parameters - HEIDENHAIN ND 282B User Manual

List of Operating Parameters

Parameter Settings / Function
Enter a code number:
P00 CODE
9 51 48:
24 65 84: To lock the keyboard
66 55 44: To show the software version
24 65 82: Distance-to-go display
Units of measurement
P01
Display in millimeters
Display in inches
Sorting and tolerance checking
P17 CLASS.
Sorting and tol. checking ON
Sorting and tol. checking OFF CLASS. OFF
P18 L.CLASS. Lower limit for sorting
P19 U.CLASS. Upper limit for sorting
Display for series of measurements
P21 M.SERIE
OFF DIFF
Display stop for measured value output
P23 DISPL.
Display equal to actual valueDISPL. ACTL.
Display equal to output
To change the protected
operating parameters
CLASS. ON
MAX ACTL MIN
DISPL. BCD
Parameter Settings / Function
Counting direction
P30 DIR
Positive counting direction with
positive direction of traverse DIRECT. POS
Negative counting direction with
positive direction of traverse DIRECT. NEG
Encoder signal subdivisions
P32 SUBD.
200 / 100 / 50 / 40 / 20 / 10 / 8 / 5 / 4 / 2 /
MM
1 / 0.8 / 0.5 / 0.4 / 0.2 / 0.1
INCH
Counting mode
P33 COUNT
0-1-2-3-4-5-6-7-8-9
0-2-4-6-8
0-5
Decimal places
P38 DEC.
1 / 2 / 3 / 4 / 5 / 6
(up to 7 for inch display)
Reference marks
P43 REF
One reference mark
Distance-coded with 500 • SP
(SP: signal period)
Distance-coded with 1000 • SP
(e.g. for HEIDENHAIN LS ...C)
Distance-coded with 2000 • SP
Distance-coded with 5000 • SP
COUNT 0-1
COUNT 0-2
COUNT 0-5
SINGLE REF.
500 SP
1000 SP
2000 SP
5000 SP
21