Table of Contents
Advertisement
Preparation for playing
Turn on the television set, amplifier or receiver to which the Player
is connected. Then select the proper channel and mode to
operate the Player, and set the sound volume to a reasonable
level.
Press the POWER button on the front panel or remote control.
ON/STANDBY
POWER
The display window shows the initial information as shown below.
Easy start up
Without pressing the POWER button you can start up the Player by
pressing 3 SELECT button or disc buttons.
Inserting/removing disc(s)
Press the 0 0 0 0 0 (OPEN/CLOSE) button (1 through 3) to open the disc
tray. Then place the disc in the round recess of the tray with label
side up. To close the tray, press the 0 0 0 0 0 (OPEN/CLOSE) button
again.
If you press the 0 (OPEN/CLOSE) button of the disc which is playing,
the Player stops and then opens the tray.
If you press the 0 (OPEN/CLOSE) button of a disc that is not being
played, you can change discs without stopping play.
Note
•
When loading a disc in the disc tray, be sure to position the disc
inside the recess. Otherwise, the disc will be damaged when the
disc tray is closed, and the disc cannot be removed from the unit.
CD
Tray
CORRECT
STANDBY
The STANDBY indicator
goes out.
INCORRECT
Starting to play disc(s)
Press the 3 3 3 3 3 SELECT (PLAY) button. The Player starts to play from
the disc indicated in the display window.
Press one of the DISC 1 through 3 buttons and the Player plays the
disc you pressed, from the 1st track. For individual track selec-
tion, use the number keys or the 4
SELECT
When you start play, the Display window shows the disc number and
the track number being played.
During play, the indicator on the DISC button blinks.
If the PBC function is activated, the display window shows "Pb" until
you play a track, and the television screen shows the initial menu, DISC
number, and "PBC". See page 18, "Operation of Playback Control
function".
When you press 3 SELECT button during play, the disc will restart
from the beginning of the track except when the PBC function is
activated.
Using number keys
Press the number keys to select numbers.
On the Player .................... 1 to 10 and +10 key
Example: For number 5, press 5. For number 15, press +10, then 5.
For number 20, press +10 button, then 10. For number 32, press +10
three times, then 2.
1
2
6
7
On the remote control ..... 1 to 10 and +10 key
Select numbers as described above.
1
2
5
6
9
10
Note
• When you press the number keys, the track will start playing without
pressing 3 SELECT button.
BASIC OPERATIONS
4 / ¢
4
4
¢
¢
¢ PREV/NEXT buttons.
4
¢
or
3
4
5
8
9
1
0
+
10
3
4
7
8
+10
Page 7
Advertisement
Table of Contents
