Transmit Power And Frequency Accuracy Test - Park Air T6M User Manual

Transmit Power and Frequency Accuracy Test

To check the base station's transmit power, and the accuracy of the carrier frequency, carry out the
following procedure:
(1) Isolate power from the base station and connect the test equipment as shown below. Ensure
the wattmeter is switched to forward power.
Transmit Power and Frequency Accuracy Test - Test Equipment Connection
(2) Reconnect the power and ensure the base station's rear panel Power switch is set to on.
(3) To enter Test mode switch on the base station by pressing, and keeping pressed, the front
panel Power button. Without releasing the Power button, press and release the SQL button,
then the SCN button, and finally the PRI button. Release the Power button.
T6M Base Station User Guide
Page 50
Base Station Front Panel Power Button Location