Opening A Saved Personality; Loading A Personality Into The Radio; Reading A Personality From The Radio - Park Air T6M User Manual

OPENING A SAVED PERSONALITY

To open a previously saved personality:
(1) From the programming menu, select File, then Open.
(2) Select one of the personality files and click on Open.

LOADING A PERSONALITY INTO THE RADIO

Use the following procedure to load a personality into the radio:
(1) Switch off the laptop (or PC) and the radio.
(2) At the radio, disconnect the microphone from the front panel. Replace it with the
programming lead.
(3) Connect the other end of the programming lead to the laptop's (or PC's) Com port 1 or Com
port 2. Note that the appropriate port is set in the personality. The connected port must match
that stated in the personality. Check, and amend if necessary.
(4) Switch on the laptop and then the base station (laptop must be switched on before the base
station). At the base station check that Pr is shown on the front panel display.
(5) Ensure the programming software is running and display the required personality on screen.
(6) From the programming menu-bar select 'Program radio' and then 'Personality'.
The programmer automatically verifies the personality is valid and downloads it to the radio. If it is not
valid the nature of the error will be displayed. The progress of the programming operation is displayed on
the status line at the bottom of the programming screen.
When programming is complete, switch off the radio and laptop, remove the programming lead,
reconnect the radio's microphone and restore the equipment ready for operational use.

READING A PERSONALITY FROM THE RADIO

To read a personality from the radio:
(1) Switch off the laptop (or PC) and the radio.
(2) At the radio, disconnect the microphone from the front panel. Replace it with the
programming lead.
(3) Connect the other end of the programming lead to the laptop's (or PC's) Com port 1 or Com
port 2. Note that the appropriate port is set in the personality. The connected port must match
that stated in the personality. Check, and amend if necessary.
(4) Switch on the laptop and then the base station (laptop must be switched on before the base
station). At the base station check that Pr is shown on the front panel display.
(5) Ensure the programming software is running.
(6) From the programming menu-bar select 'Read radio' and then 'Personality'.
The progress of the read operation is displayed on the status line at the bottom of the programming
screen.
When complete, switch off the radio and laptop, remove the programming lead, reconnect the radio's
microphone and restore the equipment ready for operational use.
T6M Base Station User Guide
Page 45