Unpacking; Setting Internal Links - Park Air T6M User Manual

UNPACKING

When the base station is received from PAE, remove the packaging and check that the items listed in
Table 3 are included.
Item
Number
1 Base station complete with enclosure
2 Microphone terminated with 7-pin DIN plug
2 metres of mains cable terminated with a
3
3-pole socket (mates with AC input plug)
15-way D-type plug (mates with Facilities
socket) comprising:
4
Plug connector
Cover
If ordered, a programming kit may be included. This kit, part number 70-T6MPMKIT, comprises:
CD containing the software.
q
Base station to PC connecting cable.
q

SETTING INTERNAL LINKS

Two internal links must be correctly set before the base station is used. Both links are factory set, but
may require checking if a replacement Interface module is fitted during the life of the base station. The
two links are:
Interface module JP1. This link determines whether received audio, or transmitted and received
q
audio, is monitored through the internal loudspeaker (see 'Local Monitoring of Transmitted
Audio' on page 11).
Interface module JP2. This link is set to correspond with the internal battery being fitted, or not
q
fitted.
When a base station is received from PAE, the links are normally set as per the user's requirements. If
there are any doubts, however, check the links as follows:
(1) Refer to Figure 5 that shows the base station in its enclosure. Remove and retain the six M4
pan head screws and associated washers that secure the equipment within the enclosure.
(2) Slide the equipment forward out of the enclosure. Refer to Figure 8 and identify the Interface
PCB. Refer to Figure 11 and identify links JP1 and JP2.
(3) Ensure the two links are set to the required positions.
(4) Slide the equipment back into its enclosure. Refit the six M4 securing screws and washers.
T6M Base Station User Guide
Page 30
Table 3. Installation Materials
Description Quantity
Part Number
1 BT6MBS
1 24-11030301
1 17-03000038S
1 20-01150100
1 20D09150101
PAE