Operating The Base Station In Priority Mode; Selecting Priority Mode; Selecting A Priority Channel Frequency; Transmitting And Receiving - Park Air T6M User Manual

OPERATING THE BASE STATION IN PRIORITY MODE

Priority mode allows faster access to frequently used channel frequencies. Up to 15 channel frequencies
can be programmed into the base station's priority list. The Priority facility must be programmed into the
base station before it can be selected, or used.
Operating the base station in Priority mode requires the following operations. Each operation is
explained in following paragraphs.
(1) Select Priority mode if not currently selected.
(2) Select the required channel frequency.
(3) Transmit using the fist microphone, and receive using the base station's internal
loudspeaker.

Selecting Priority Mode

Select Priority mode by pressing the PRI button. When selected, the display shows 'P' every few
seconds.

Selecting a Priority Channel Frequency

To select the required channel frequency, press the SEL
the priority channel frequencies that are programmed into the base station. Release the button when the
required frequency is displayed.

Transmitting and Receiving

To transmit, key the transmitter by pressing the fist microphone's PTT button. Check that the base
station's Tx indicator lights, and then speak clearly into the microphone.
Reception is heard through the base station's internal loudspeaker. The volume is adjusted using the
front panel's rotary Volume control that must be pushed in to switch on the loudspeaker. Users should
note that the VOL and VOL
base station's busy indicator lights if squelch is switched on; if squelch is switched off, the busy indicator
is permanently lit. If the squelch facility requires adjusting, use the procedure 'Switching and Adjusting
the Squelch Facility' given on page 21.
buttons do not adjust the volume. When a signal is received, the
or SEL button to scroll up or down through
T6M Base Station User Guide
Page 23