Fault And Error Codes - Park Air T6M User Manual

FAULT AND ERROR CODES

A number of fault and error codes are shown on the radio's display if an internal fault is detected. The
codes and their meaning are detailed in Table 2.
Displayed
Fault or Title
Error Code
Synthesiser
F1
failure
Unstable
F2
output
Over
F4
temperature
High reflected
F8
power
F16 Low supply
voltage
F32 High supply
voltage
cErr Critical error
T6M Base Station User Guide
Page 28
Table 2. Fault and Error Codes
An internal fault on the synthesiser has been detected. Switch off the base
station and switch on again after a few minutes. If the fault persists, refer to
'Maintenance' in chapter 7.
An internal fault on the power amplifier has been detected. Switch off the base
station and switch on again after a few minutes. If the fault persists, refer to
'Maintenance' in chapter 7.
This condition may occur if the transmitter's duty cycle has been exceeded, or
when transmitting for long periods. The fault should clear if the radio is not
keyed and allowed to cool.
Indicates a faulty antenna, antenna cable, or RF connector.
These two faults indicate the internal power supply is faulty. Switch off the base
station and switch on again after a few minutes. If the fault persists, refer to
'Maintenance' in chapter 7.
Fault code F16 may be displayed when operating using the battery option and
the battery starts to run flat.
This error is displayed when the base station is initially switched on and no
personality information, or corrupted personality information, is detected. Refer
to 'Programming the Base Station' on page 37 and load a personality into the
base station.
Meaning