VeriFone UX300 Installation Manual page 22

S
ETUP
Mounting the Device
NOTE
NOTE
NOTE
NOTE
22
UX300 M C
ANUAL ARD
3
Flush-mount the reader at a 30° angle, for optimum performance of the card
entry slot.
Your device may come with an optional cable retainer. If so, place the cable
retainer by the base of the cable connector, and align the studhole of the cable
retainer with the mounting hole of the unit.
The cable retainer is then secured along with the unit with the M5 nut (see
Step 4).
4
Secure the unit with M5 nuts.
Use M5 mounting studs with a minimum length of 12 mm.
Tighten the nuts, using a recommended tightening torque of 7.0 kgfcm.
1
Figure 10 Mounting the Card Reader/Controller
Another mounting option is using welded screw bolts on the inner side of the
mounting plate. This may be used in order to prevent any vandalism by way of
the screw heads on the outer surface.
5
Connect one side of flexible tubing to the nozzle on the bottom of the unit (see
Figure 2).
6
Hang the other side of the tube out of the VM, or other outside unit.
The nozzle is designed to drain water out of the bezel area, through the flexible
tube.
R I G
EADER NSTALLATION UIDE
2