VeriFone UX300 Installation Manual page 19

NOTE
To connect the UX300
to the UX400 CTLS
unit
Connecting to Other
Optional Devices
Connecting to a UX200 Media Display Unit
The UX300 unit is designed to connect to a UX200 media display. Connect to the
peripheral display unit through any one of these two connection types:
•
USB Type A
•
ETH (LAN)
Connect the appropriate cable to the UX300 unit and the other end to the media
display.
For more information regarding your card reader configuration and your cabling
needs, contact your local VeriFone service provider. For cable ordering
information, see Accessories and
The UX300 connects to the UX200 media display as both a peripheral device, as
well as a host unit. To see how to connect to the UX200 as a host unit, see
Connecting to a UX-Series Host
Connecting to a UX400 CTLS Unit
The UX300 unit is designed to connect to a UX400 contactless unit using an
8-pin—RJ-45 connector and an SMA connector.
1
Connect the 8-pin connector to the UX300 unit.
2
Connect the RJ-45 plug to the rear of the contactless unit.
3
Screw in the SMA connector to the UX300 unit.
4
Screw in the SMA connector to the rear of the contactless unit.
5
Connect the RF antenna cable to the UX300 unit and the other end to the
CTLS unit and screw tightly by hand.
For further cabling instructions, see
Figure 8 Connecting to a UX400 CTLS Unit
The UX300 device can connect to various peripheral devices, outside of the UX-
Series product range. Such products include:
•
Connecting to a Printer
Documentation).
Device.
Figure 8.
RJ-45
SMA
SMA
8-Pin
UX300 M
ANUAL
Cable Connections
UX300
C R I
ARD EADER NSTALLATION
S
ETUP
19
G
UIDE