Cylinder Head Removal: Rocker Carrier - International VT 275 V6 Manual

UNIQUE REPAIR PROCEDURES
8 8 M M M M B B O O L L T T S S ( ( 6 6 ) )
Cylinder Head Removal Continued
• The rocker arms, push rods and valve
bridges must be installed in their original
position during reassembly.
• The valve bridges can be marked with a
permanent marker during disassembly.
• Note: If the rocker arms and/or valve
bridges are not correctly
premature valve train wear may result.
80
H H E E A A D D B B O O L L T T S S ( ( 8 8 ) )
installed
International ® VT 275 V6 Engine

Cylinder Head Removal: Rocker Carrier

• The rocker arm carrier is held in place with
six small bolts and eight cylinder head bolts.
• Four additional small bolts at the top hold
the cylinder head to the crankcase.
• Note: When any of the eight large cylinder
head bolts are removed the head gasket
and the cylinder head bolts must be
replaced.
V V A A L L V V E E B B R R I I D D G G E E ( ( I I N N T T A A K K E E ) )
V V A A L L V V E E B B R R I I D D G G E E ( ( I I N N T T A A K K E E ) )
V V A A L L V V E E
V V A A L L V V E E
B B R R I I D D G G E E
B B R R I I D D G G E E
( ( E E X X H H A A U U S S T T ) )
( ( E E X X H H A A U U S S T T ) )