Seal Installer Base; Installing Seal & Wear Sleeve; Flexplate Bolts - International VT 275 V6 Manual

Seal Installer Base

• Place a 360° bead of Loctite® Hydraulic
Sealant on the outer circumference of the
crankshaft flange. Bolt the base of the rear
main seal/wear sleeve installer to the
crankshaft. Make sure the crankshaft
dowel pin is in the recess provided in the
face of the tool. Lubricate the outer
diameter of the seal with a 50/50 mixture
of soap and water (do not use any other
lubricant). Side the seal over the base.
Installing Seal & Wear Sleeve
• Position the rear seal/wear sleeve installer
on the base. Place the thrust bearing and
drive nut on the threaded shaft. Tighten the
nut until the rear main oil seal bottoms out
in the rear oil seal carrier. After the seal
bottoms out remove the installer tool and
base and install the flywheel adapter,
making sure the dowel pin is lined up with
the adapter holes.

Flexplate Bolts

• The flexplate bolts are not reusable. Install
ten new flexplate bolts. Tighten all bolts in
sequence to specification using the torque
sequence. Use an alternating pattern
across the center to evenly pull down
the flexplate.
UNIQUE REPAIR PROCEDURES
S S E E A A L L I I N N S S T T A A L L L L E E R R S S E E A A L L I I N N S S T T A A L L L L E E R R
B B A A S S E E
B B A A S S E E
S S E E A A L L I I N N S S T T A A L L L L E E R R
S S E E A A L L I I N N S S T T A A L L L L E E R R
1 1
1 1
7 7
7 7
9 9
9 9
6 6
6 6
International ® VT 275 V6 Engine
2 2
2 2
5 5
5 5
1 1 0 0
1 1 0 0
8 8
8 8
4 4
4 4
3 3
3 3
73