Replacing Turbocharger Crossover Seal; Installing Seal - International VT 275 V6 Manual

UNIQUE REPAIR PROCEDURES
C C R R O O S S S S O O V V E E R R T T U U B B E E
C C R R O O S S S S O O V V E E R R T T U U B B E E
S S E E A A L L P P U U L L L L E E R R
S S E E A A L L P P U U L L L L E E R R
S S E E A A L L I I N N S S T T A A L L L L E E R R
S S E E A A L L I I N N S S T T A A L L L L E E R R
76

Replacing Turbocharger Crossover Seal

• Place the holding fixture of the crossover
tube seal installing tool into a vise. Clamp
the crossover pipe into the fixture. Screw
the threads of the removal tool
into the seal.
H H O O L L D D I I N N G G F F I I X X T T U U R R E E
H H O O L L D D I I N N G G F F I I X X T T U U R R E E
Removing Seal
• Install a side hammer into the seal remover
tool and pull the seal out.

Installing Seal

• Drive a new seal into the crossover tube
using the seal driver and a hammer. Install
a new O-ring on the other end of the
crossover tube. Assemble the crossover
tube to the turbocharger so the clamp bolt
will be vertical with the turbocharger on the
engine. A small amount of soap and water
solution maybe needed to get the seal over
the turbine inlet.
International ® VT 275 V6 Engine