Grandstream Networks HT801 Administration Manual page 23

Settings" page. Password field is purposely left blank for security reasons after clicking
update and saved. Max. length is 25 characters.
Confirm Admin
Confirms the new admin password.
Password
Layer 2 QoS
Sets values for 802.1Q/VLAN Tag. Default is 0. Valid range is 0-4094.
SIP 802.1p. Default is 0. Valid range is 0-7.
RTP 802.1p. Default is 0. Valid range is 0-7.
STUN Server is
Configures IP address or domain name of STUN server. Only non-symmetric NAT
routers work with STUN.
Keep-alive interval Sends periodically a blank UDP packet to SIP server in order to keep the "ping hole" on
the NAT router open. Default is 20 seconds.
Use STUN to Uses STUN keep-alive to detect WAN side network problems. If keep-alive request does
detect not yield any response for configured number of times (minimum 3), the device will
restart the TCP/IP stack. If the STUN server does not respond when the device boots
network
connectivity up, the feature is disabled. Default setting is No.
Use DNS to detect Uses DNS to detect WAN side network problems. Default setting is No.
network
connectivity
Verify host when Enables / disables the host verification when using HTTPS.
using HTTPS
Upgrade via
Selects firmware upgrade/provisioning method: TFTP, HTTP or HTTPS.
Firmware Server
Sets IP address or FQDN of firmware server. The URL of the server that hosts the
Path
firmware release. Default is fm.grandstream.com/gs.
Config Server Path Sets IP address or FQDN of configuration server. The URL of the server that hosts the
configuration file to provision HT801. Default is fm.grandstream.com/gs.
XML Config File Decrypts XML configuration file when encrypted. The password used for encrypting the
Password XML configuration file using OpenSSL.
HTTP/HTTPS User
Enters user name to authenticate with HTTP/HTTPS server.
Name
HTTP/HTTPS
Enters password to authenticate with HTTP/HTTPS server.
Password
HT801 Administration Guide
P a g e | 22