Download Print this page

XAC FD130 Installation Manual

All in one payment terminal

Download this manual

L L L

AYMENT

NST

TALLATIO

ERMINAL

UIDE

FD130

Table of Contents

Page 1 FD130 L L L AYMENT ERMINAL TALLATIO UIDE ...
Page 2: Before Starting
1. B EFORE TARTING Open the gate behind the device (Figure 1), and find the power input on the right side of the terminal. Connect the plug from the power adapter into the power input (Figure 2). Plug the power adapter into a 120-volt electrical outlet or into a surge suppressor (recommended) after the power cord is connected to the power adapter.
Page 3: Card Reader
Contactless reader antenna is around the display and PIN pad. It will light up with blue color signal when FD130 is powered on and that means reader is working normally. Put contactless card to approach the antenna of card reader (Figure 13) for reading the card data during transaction.
Page 4: Installing The Privacy Shield
RIVACY HIELD The privacy shield of the FD130 is shown as figure 18. To install, place the privacy shield over the terminal and hook the top hooks to the device basins beside keypad number 1 and 3. Whilst hooked on, apply pressure to the bottom part of the shield so that it clicks into the bottom hooks shown on figure 19.
Page 5 See installation instructions for details. Warning: If the device, FD130, is used without the detachable privacy shield, the following criteria needs to be met by the Installed Environment of the PED for complying with the PCI privacy screen design requirement: A.

Fd130t