Jacobsen AR522 Safety, Operation And Maintenance Manual page 20

4 CONTROLS
A. Tilt Steering Lever
Pull lever up to release steering column. Tilt
column up or down to position desired.
Release lever to lock steering column in
place.
!
CAUTION
Never adjust steering while mower is moving. Stop
unit and set parking brake before adjusting.
B. Mow Speed Stop
Limits forward speed while mowing. To operate at
lower travel speed while mowing, rotate lever so it
contacts stop screw (B
travel pedal is pressed. To travel at full speed, set
lever in position shown (B
adjusted to set specific mow speeds. See Section
8.2.
C. Traction Pedal - Forward
Press front of pedal down for forward travel. Release
pedal to slow mower and stop.
D. Traction Pedal - Reverse
Press rear of pedal down for reverse travel. Release
pedal to slow mower and stop. Allow mower to come
to a complete stop before reversing directions.
B
3
Transport Speed
E. Seat Adjustment
Pull left side lever out to adjust seat forward or
backward. To adjust spring tension under seat turn
adjusting knob on front of seat.
F. Hydraulic Oil Cap / Dipstick
Fill to mark on dipstick using clean hydraulic fluid
while machine is cool. Do not overfill.
G. Air Cleaner Indicator
Indicates condition of air cleaner on engine. Clean or
replace air filter when red band appears in clear
window of indicator. See Section 7.4.
20
) on floor board when forward
1
). Stop screw (B ) can be
3 2
B
1
B
2
C
D
Mow Speed
Figure 4A
H. Fuel Cap
Fill fuel tank with No. 2 diesel fuel, minimum Cetane
Rating of 45. See Section 5.11.
J. Alarm
The alarm, along with the warning lights on the
combination gauge (V), sounds to alert the operator
to conditions requiring immediate attention. See
Section 4.4.
K. Controller / Fuses
The controller is located under the rear hood directly
behind the operator's seat. It is equipped with lights
to aid in monitoring and problem solving the electrical
system of the mower.
Two spade type fuses are located on the controller.
To replace fuses remove the access panel.
!
CAUTION
Service to the electrical system must be performed by
a trained technician. Before replacing fuses turn
mower off and remove key from ignition.