Table of Contents
Advertisement
Chapter 5
Initial Configuration
Downloading Software Using Cisco WCS
To download software to a mobility services engine using Cisco WCS, follow these steps:
Step 1
Verify that you can ping the mobility services engine from Cisco WCS or an external FTP server,
whichever you are going to use for the image download.
Step 2
In Cisco WCS, click Mobility > Mobility Service Engines.
Step 3
Click the name of the mobility services engine to which you want to download software.
Step 4
Click Maintenance (left panel).
Step 5
Click Download Software.
Step 6
To download software, do one of the following:
•
•
Step 7
Enter the time in seconds (between 1 and1800) after which software download times out.
Note
Step 8
Click Download to send the software to the /opt/installers directory on the mobility services engine.
Step 9
After the image has been transferred to the mobility services engine, log into the mobility services
engine CLI and run the installer image from the /opt/installers directory by entering the ./.bin mse image
command.
To start running the software, enter /etc/init.d/msed start.
Step 10
Note
To stop running the software, enter /etc/init.d/msed stop. To check the status, enter /etc/init.d/msed
status.
Manually Downloading Software
If you do not want to automatically update the mobility services engine software using Cisco WCS,
follow these steps to upgrade the software manually using a local (console) or remote (SSH) connection.
Step 1
Transfer the new mobility services engine image onto the hard drive.
a.
OL-17304-02
To download software listed in the Cisco WCS directory, select from the uploaded images to transfer
into the server. Then, choose a binary image from the drop-down menu.
Cisco WCS downloads the binary images listed in the drop-down menu into the FTP server directory
you have specified during the Cisco WCS installation.
To use downloaded software available locally or over the network, select Browse a new software
image to transfer into the server and click Browse. Find the file and click Open.
This time-out setting represents the total time allowed before a software download to a mobility
services engine expires. It is not an FTP packet time-out setting.
Log in as root, and use the binary setting to send the software image from an external FTP server
root directory.
Downloading Software Using Cisco WCS
Cisco 3310 Mobility Services Engine Getting Started Guide
5-15
Advertisement
Table of Contents
