Table of Contents
Advertisement
Configuring the Mobility Services Engine
Enter GRUB Password:
Verify GRUB Password:
UP = 2, LO = 6, DIGIT = 3, PUNCT = 0
Password must contain 2 uppercase, 2 lowercase letters,
2 digits and 2 special characters. Try again.
Enter GRUB Password:
Verify GRUB Password:
Step 29
Enter Y to enable and define a Cisco WCS communication password.
Note
Configure WCS communication password? (Y)es/(S)kip/(U)se default [Skip]:
Enter a password for the admin user.
The admin user is used by the WCS and other northbound systems
to authenticate their SOAP/XML session with the server.
Once this password is updated, it must correspondingly be updated
on the WCS page for MSE General Parameters so that the WCS can
communicate with the MSE.
Step 30
At the prompts shown below, enter a password for Cisco WCS communication and confirm it by typing
it again. What you type is not visible.
Enter WCS communication password:
Confirm WCS communication password:
It is recommended that you set a BIOS password to prevent unauthorized BIOS access.
Note
All of the information that was entered using the Setup Wizard appears on the screen. After the script
Step 31
configuration appears on the screen, you must verify that all the setup information is correct. At the
following prompt, enter Yes to proceed with the configuration, No to make more changes, or ^ to go back
to the previous step.
Is the above information correct (yes, no, or ^):
If you enter yes, the configuration information is applied.
Note
Please verify the following setup information.
--------------------------------------------------------------------------------------------------------
Host name= mse-nyc
Domain=cisco.com
Eth0 IP address=10.71.132.233, Eth0 network mask=255.255.254.0
Default gateway=10.71.132.1
Enable DNS=yes, DNS servers=10.68.226.120
Enable NTP=yes, NTP servers=1.ntp.esl.cisco.com
Login banner =
Cisco Mobility Service Engine.
Enable Remote Root Login=no
Enable SSH root access=yes
Enable Single User Mode Password Check=no
Password/Login parameters :
Cisco 3310 Mobility Services Engine Getting Started Guide
5-10
This password does not define an individual user password for access to the Cisco WCS GUI.
This password is used for SOAP/XML authentication between systems (such as mobility
services engines) and Cisco WCS.
The text below illustrates an example of the settings displayed.
Chapter 5
Initial Configuration
OL-17304-02
Advertisement
Table of Contents
