Table of Contents
Advertisement
Configuring the Mobility Services Engine
Enter the Ethernet-0 settings for the following prompts:
Step 13
Enter an IP address for the first ethernet interface of this machine.
Enter eth0 IP address [10.0.132.233]:
Enter the network mask for IP address 10.0.132.233:
Enter network mask [255.255.254.0]:
Enter a default gateway address for this machine.
Note that the default gateway must be reachable from the first ethernet interface
Enter default gateway address [10.0.132.1]:
The second ethernet interface is currently disabled for this machine.
Configure eth1 interface parameters? (Y)es/(S)kip/(U)se default [Skip]:
If you want to provide information for a second Ethernet (eth1) interface, enter Y or yes.
Step 14
Enter an IP address and network mask for the second Ethernet (eth1) interface at these prompts:
Step 15
Enter eth1 IP address [none]:
Enter network mask [255.0.0.0]:
Step 16
If you entered an IP address and mask for the second Ethernet interface (eth1) of this machine, you can
define up to two static routing entries for that interface. Static routes are typically used in lab
environments to mimic out-of-band networks and are not recommended for use within your network
unless you have extensive experience with them. For the following prompts, enter the network address,
network mask, and gateway address for the static route:
Enter network [none]:
Enter network mask [255.0.0.0]:
Enter gateway address:
Note
Note
Step 17
If you want to configure DNS settings, enter Y at the prompt shown below:
Domain Name Service (DNS)Setup
DNS is currently enabled.
No DNS servers currently defined
Configure DNS related parameters? (Y)es/(S)kip/(U)se default [Skip]:Y
Step 18
Enter the DNS settings for the prompts shown below:
Enable DNS (yes/no) [yes]:
Enter primary DNS server IP address:
Enter backup DNS server IP address (or none) [none]:
Cisco 3310 Mobility Services Engine Getting Started Guide
5-6
If you do not want to configure any static routes, enter none at the first network address prompt.
You will not be prompted for the network mask and gateway address.
If you want to configure only one route, you can enter none when you are prompted for the
second network address.You will not be prompted for the network mask and gateway address for
the second route.
Chapter 5
Initial Configuration
OL-17304-02
Advertisement
Table of Contents
