Polaris SPORTSMAN 600 Service Manual page 42

result.
5. Allow oil to drain completely.
6. Replace the sealing washer on drain plug.
NOTE: The sealing surfaces on drain plug and oil
tank should be clean and free of burrs, nicks or
scratches.
7. Reinstall drain plug and torque to 14 ft. lbs. (19
Nm).
8. Place shop towels beneath oil filter. Using Oil
Filter Wrench (PV- -43527),
counterclockwise to remove.
9. Using a clean dry cloth, clean filter sealing surface
on crankcase.
10. Lubricate O-ring on new filter with a film of fresh
engine oil. Check to make sure the O-ring is in
good condition.
11. Install new filter and turn by hand until filter gasket
contacts the sealing surface, then turn an
additional 1/2 turn.
12. Remove dipstick and fill sump with 2 quarts (1.9 l)
of Polaris Premium 4 Synthetic Oil (PN 2871281).
2.24
Oil Filter
(PN 2540006)
turn filter
Recommended Engine Oil
Polaris Premium 4 All Season Synthetic,
0W- -40 (PN 2871281)
Ambient Temperature Range:
-40_ F to 120_ F
Crankcase Drain Plug Torque:
20- -22 ft. lbs. (27- -30 Nm)
Oil Filter Torque:
Turn by hand until filter gasket
contacts sealing surface, then
turn an additional 1/2 turn
Oil Filter Wrench:
(PV- -43527)
13. Place gear selector in neutral and set parking
brake.
14. Start the engine and let it idle for one to two
minutes. Stop the engine and inspect for leaks.
15. Re-check the oil level on the dipstick and add oil
as necessary to bring the level to the upper mark
on the dipstick.
16. Dispose of used filter and oil properly
STEERING
The steering components should be checked
periodically for loose fasteners, worn tie rod ends, and
damage. Also check to make sure all cotter pins are
in place. If cotter pins are removed, they must not be
re-used. Always use new cotter pins.
Replace any worn or damaged steering components.
Steering should move freely through entire range of
travel without binding. Check routing of all cables,
hoses, and wiring to be sure the steering mechanism
is not restricted or limited. NOTE: Whenever steering
components are replaced, check front end alignment.
Use only genuine Polaris parts.
MAINTENANCE
.