Bar Code Scanner
Using the Bar Code
Scanner
Scanning a Bar Code
August 1, 2003
The ROP has a bar code scanner attached to the front of the unit and is used
for scanning cassette ID's, technologist ID's, and configuration bar codes.
Touch the appropriate button to access the other servers.
Use the bar code scanner to read the bar codes on cassettes, forms, etc. to
enter information directly into the CR System. The following fields can be
completed using the bar code scanner on the ROP:
• Accession Number
• Patient ID Number
• Technologist ID Number
• Cassette ID bar code
The Key Operator can program the bar code scanner to read bar codes
automatically or manually.
Position the bar code scanner 3-8 inches (9-27 cm) from the bar code
1.
and center the bar code scanner horizontally on the bar code so the light
falls on the bar code.
NOTE: Bar codes must be limited to 35 characters.
For manual operation, squeeze and hold the trigger until the red light
2.
goes out and you hear a high-pitched beep.
For automatic operation, hold the bar code being read under the light
3.
until you hear a high-pitched beep.
1F1976
Remote Operations Panel
10-15