To Install The Lcd Module Assembly - Motorola MTH500 Service Manual

68P02963C70-O

To install the LCD module assembly:

NOTE: Do not touch the LCD module assembly in the active viewing area;
fingerprints on this surface cannot be easily removed.
1. Locate the LCD module above the LCD board so that the two guide pins are aligned
with the holes in the LCD board.
2. Gently push the module down, right snaps first and then left snaps.
3. Verify that the snaps are located correctly inside the board slots.
4. Remove the protective film from the LCD glass. Verify that no damage exists on the
LCD glass.
5. Install the LCD board, refer to "Removing and Installing the Keypad and LCD
Boards".
LCD Module
Snaps
(X4)
Figure 20
LCD Board
LCD Module Removal and Installation
Maintenance
LCD Module
5 - 13