To Install The Battery; To Install The Battery Door; Removing And Installing The Back Housing; Removing The Back Housing From The Unit - Motorola MTH500 Service Manual

Maintenance

Removing and Installing the Back Housing

5 - 6

To install the battery:

1. Locate the battery so that the lower part (coloured silver) is touching the lower wall of
the battery chamber.
2. Carefully press the battery down until it snaps into location.

To install the battery door:

1. Position the door on the unit over the battery so that the door release button is just
above the battery fastening bridge.
2. Slide the door upward until the door snaps into location.
3. Verify that the door is aligned with the handset back housing.
Recommended tools: T-8 Torx bit, Torx driver, mini flat-tip screwdriver

Removing the back housing from the unit:

(See Figure 16)
1. Remove the antenna, refer to "Removing and Installing the Antenna".
2. Remove the battery door and the battery, refer to "Removing and Installing Battery
Door and Battery".
3. Place the unit facing down on the work area.
4. Using the screwdriver remove the oval label at the top of the unit and the tamper evi-
dent label in the center to enable access to all six screws fastening the back housing.
Clean the adhesive remains of the tamper evident label using alcohol.
5. Using the Torx driver with the T-8 Torx bit, unscrew the six screws fastening the back
housing.
6. Carefully remove the back housing from the unit.
68P02963C70-O