Table of Contents
Advertisement
CD player operation
(a) Inserting or ejecting CD's
The ignition switch must be in the "ACC" or "ON" position.
Your CD player with changer can store up to 6 CD's.
D Setting a single CD:
1. Push the "LOAD" button briefly.
The amber indicators at either side of the slot start blinking and
"WAIT" appears on the display. After the blinking indicators
change to green, stay on and "WAIT" changes to "LOAD", the
CD door opens.
2. Insert only one CD while the CD door is open.
You can set a CD at the lowest empty CD number.
After insertion, the set CD is automatically loaded.
If the label faces down, the CD cannot be played. In this case,
"ERROR 1" and CD number appear on the display.
If you need to insert the next CD, repeat the same procedure
to insert another CD.
D Setting all the CD's:
1. Push the "LOAD" button until you hear a beep.
The amber indicators at either side of the slot start blinking and
"WAIT" appears on the display. After the blinking indicators
change to green, stay on and "WAIT" changes to "LOAD", the
CD door opens.
2. Insert only one CD while the CD door is open.
The CD door closes and "WAIT" appears again.
3. Insert the next CD after "WAIT" changes to "LOAD" and
the CD door opens.
4. Repeat this procedure until you insert all the CD's.
To cancel the operation, push the "LOAD" or "DISC" button.
If you do not insert CD's within 15 seconds after pushing the
"LOAD" button and "LOAD" is displayed, the operation will be
canceled automatically.
NOTICE
Do not insert one CD stacked on top of another one or
feed them in continuously, to prevent CD's from getting
stuck in the player.
AUDIO
241
Advertisement
Table of Contents
