Viewing the clock
The clock (if it is set) will be shown in Standby
mode. Press CLOCK on the system to view
clock in any source mode (or press CLOCK/
TIMER on the remote control).
Press DISPLAY on the system to select 12-
hour or 24-hour mode.
If the clock has not been set, "--:--" will blink
until you set the clock.
Setting the clock - see page 19.
Setting the timer
The system can switch to DISC, TUNER, TAPE
mode automatically at a preset time, serving as
an alarm to wake you up.
IMPORTANT !
– Before setting the timer, ensure that
the clock is set correctly.
– The timer will always be switched on
once set.
– The timer will not start if a recording
is in progress.
– The volume of the timer will increase
gradually from the minimum level to the
last tuned volume level.
– The time can be set in 24-hour mode.
1
Press and hold TIMER or CLOCK/TIMER for
more than 3 seconds,
TIMER
will start to flash.
The selected source will be displayed.
Clock/Timer Operations
2
Press DISC, TUNER or TAPE (1/2) to select
timer mode. The corresponding source will
appear on the display.
DISC - load the disc.
TUNER - Tune to the desired radio station.
TAPE 1 - Load the prerecorded tape into tape
deck 1.
3
Press O or P on the system or remote control
to set hours .
4
Press 1 or ¡ on the system or remote
control to set the minutes.
5
Press TIMER or CLOCK/TIMER to store the
setting.
"TIMER ON" will be displayed for 3 seconds.
The timer will start to work.
The timer will always be switched on once it
has been set.
41