Clock/Timer Operations; Viewing The Clock; Setting The Clock; Setting Wake-Up Timer - Philips FWD397/98 User Manual

Clock/Timer Operations

Viewing the clock

The clock (if it is set) will be shown in standby
mode.
To view the clock in any source mode
(DISC or TUNER) for example:
1
Press CLOCK on the system.
➜
The clock is displayed for a few seconds.
➜ If the clock has not been set, "NO CLOCK" is
displayed for a few seconds.

Setting the clock

1
In standby mode, press and hold CLOCK on
the system.
➜
The clock digits flash on the display panel.
➜
If the clock has not been set, "--:--" flashes
2
Press PRESET O / P repeatedly to set the
hour.
3
Press SEARCH•TUNING 1 / ¡
repeatedly to set the minute.
4
Press DISPLAY/OSD repeatedly to switch to
between 12-hour and 24-hour display.
5
Press CLOCK again to store the setting.
➜
The clock starts working.
Notes:
– The clock setting will be erased when the
system is disconnected from the power supply.
– The system will exit clock setting mode if no
button is pressed within 10 seconds.
– To exit clock setting without storing, press 9 on
the system to exit.
Setting the wake-up timer
The system can switch on to DISC, USB or
TUNER mode automatically at a preset time,
serving as an alarm to wake you up.
Important!
– Before setting the timer, ensure that
the clock is set correctly.
– To set a new timer, you need to
deactivate the previously set timer.
1
In standby mode, press and hold TIMER/
SLEEP on the remote for more than five
seconds to enter timer setting mode.
➜
The source and timer digits will be light on
the display panel.
38
2
Press DISC1/2/3, USB or TUNER to select
the desired source.
●
Before setting timer, make sure the music source
has been prepared.
DISC1/2/3 – load the disc(s).
USB – insert a USB driver.
TUNER – tune to the desired radio station.
3
Press PRESET O / P repeatedly to set the
hour.
4
Press SEARCH•TUNING 1 / ¡
repeatedly to set the minute.
5
Press TIMER/SLEEP to store the time.
●
At the preset time, the selected source will be
played.

Viewing the timer

1
In standby mode, press TIMER/SLEEP to view
timer (e.g "DISC 03:03"), Timer will be shown
on the display for a few seconds and then go
back to it's previous status.
2
If timer have not been set, "TIMER OFF" will
be displayed for a few seconds.
To deactivate the wake-up timer
● In standby mode, press TIMER/SLEEP to the
view timer mode, then press 9 until " TIMER
OFF" is displayed on the panel. ( press 9 again
to switch to "TIMER ON" )
Notes:
– The system will exit timer setting mode if no
button is pressed within 10 seconds.
– Display shows if timer is activated, and
disappears if it is inactivated.
Setting the sleep timer
The sleep timer enables the system to switch off
by itself after a set period of time.
1
Press TIMER/SLEEP on the remote control
repeatedly to select a preset time.
➜
The selections are as follows (time in
minutes):
➜ ➜ ➜
15 30 45
2
Press TIMER/SLEEP until you reach the
desired length of time.
To deactivate the sleep timer
● Press TIMER/SLEEP repeatedly until "OFF" is
displayed, or press B.
➜ ➜ ➜
60 90 120 OFF