Clock/Timer Operations; Viewing Clock; Setting The Timer - Philips FW-D750 Manual

- -

Viewing clock

The clock (if it is set) will be shown in Standby
mode.
● Press DISPLAY to select 12-hour or 24-hour
mode.
➜ If the clock has not been set, "--:--" will blink
(1 kHz) until you set the clock.
Setting the clock - see page 19.

Setting the timer

The system can switch to DISC, TUNER, TAPE
or AUX mode automatically at a preset time,
serving as an alarm to wake you up.
IMPORTANT !
– Before setting the timer, ensure that
the clock is set correctly.
– The timer will always be switched on
once set.
– The timer will not start if a recording
is in progress.
– The volume of the timer will increase
gradually from the minimum level to the
last tuned volume level.
– The system will bring the timer
forward 1 minute to turn on.
– The time can be set in 24-hour mode.
1
Press STANDBY ON on the system to
STANDBY mode.
- - -
1 2 3
-
DYNAMIC AMPLIFICATION CONTROL

Clock/Timer Operations

wOOx
2
Press TIMER to select timer mode.
➜ TIMER
will start to flash.
➜ The selected source will be displayed.
3
Press DISC, TUNER or TAPE to select timer
mode. The corresponÍding source will appear on
the display.
DISC - load the disc. To start from the specific
track programmed. (refer to page 24, Disc
Operations - program favorite tracks").
TUNER - Tune to the desired radio station.
TAPE2 - Load the prerecorded tape into tape
deck 2.
4
Press O or P on the system to set hours .
Press 1 or ¡ on the system to set the
5
minutes.
6
Press TIMER to store the start time.
➜ "TIMER ON" will be displayed for 3 seconds.
➜ The timer will start to work.
● At the preset time, the selected source
will play before it switches to Eco Power
standby mode (if no button is pressed within
the time frame).
To exit without storing the setting
● Press 7 on the system.
To deactivate the timer
● Press and hold TIMER for more than 3 seconds.
A-B
39