Connections; Step 1: Placing Speakers And Subwoofer; Step 2: Connecting Speakers And Subwoofer; Center - Philips FWD796/21 User Manual

Connections

Step 1: Placing speakers and

subwoofer

subwoofer
Rear speaker
( left surround )
For best possible surround sound, all speakers
(except subwoofer) should be placed at the
same distance from the listening position .
Place the front left and right speakers at equal
distances from the TV set and at an angle of
approximately 45 degrees from the listening
position.
place the center speaker above the TV set or the
system so the center channel's sound is localized.
Place the surround speaker at normal listening
ear level facing each other or mounted on the
set .
Place the subwoofer on the floor near the TV
set.
Notes:
– To avoid magnetic interference, do not position
the front speakers too close to your TV set.
– Allow adequate ventilation around the DVD Mini
Hi-Fi System.
IMPORTANT!
The type plate is located on the rear of
the system.
To avoid overheating of the system, a
safety circuit has been built in. Therefore,
your system may switch to Standby
mode automatically under extreme
conditions. If this happens, let the system
cool down before reusing it.
10
Step 2: Connecting speakers and
Rear speaker
( right surround )
Connect the speaker wires to the SPEAKERS
(FRONT) terminals, right speaker to "R" and left
speaker to "L", coloured (marked) wire to "+"
and black (unmarked) wire to "–". Fully insert the
stripped portion of the speaker wire into the
terminal as shown.
Connect the Surround Speakers and Center
Speaker system using the supplied speaker cable
to the speaker jacks on the SUBWOOFER by
matching the colours of the jacks and speaker
plugs.
Connect the subwoofer using the supplied
speaker cable to the DIN OUT jack on the DVD
Mini Hi-Fi System.
Connect the AC MAINS .
Front Left(L)
Front Right(R)

Center

Surround(Rear) Left(L)
Surround(Rear) Right(R)
Notes:
– For optimal sound performance, use the supplied
speakers.
– Do not connect more than one speaker to any
one pair of +/- speaker terminals.
– Do not connect speakers with an impedance
lower than the speakers supplied. Please refer to
the SPECIFICATIONS section of this manual.
subwoofer
speakers
Black
Black
Black
Black
Black
– –
+
White
Red
Green
Blue
Grey