Capacity Indicator; Capacity Indicator Cable Adjustment; Capacity Indicator Boom Tape Replacement; Installation Procedure - JLG 80HX Service Maintenance Manual

SECTION 2 - PROCEDURES

2.32 CAPACITY INDICATOR

The capacity indicator is a mechanical gage that indicates
the allowable maximum weight in the platform in reference
to the angle of the boom.
THE CABLE ADJUSTMENT AND DECAL REPLACEMENT ARE
CRITICAL TO INSURE AN ACCURATE READING OF THE CAPAC-
ITY INDICATOR.

Capacity Indicator Cable Adjustment.

1. Position main boom top plate and platform to be
parallel to the floor.
2. Adjust the cable to locate the dial in the capacity
indicator box so that the indicator line and calibra-
tion arrows on the nameplate are aligned.

Capacity Indicator Boom Tape Replacement

Replacement of boom tape is required when tape is illegi-
ble or missing.
THE LOCATION DIMENSIONS AND COLORS ARE CRITICAL FOR
AN ACCURATE READING OF THE CAPACITY INDICATOR GAGE.

Installation Procedure

1. Clean and dry fly boom top surface before installing
the tape.
2. install tape on center of fly boom to dimensions
shown in table.
2-66
Figure 2-38. Boom Tape Replacement

Capacity Indicator Dial Decal Replacement.

Dial decal is required to be replaced when illegible or
missing.
DECAL LOCATION DIMENSIONS ARE CRITICAL FOR ACCURATE
READING OF CAPACITY INDICATOR.

Indicator Decal Installation

1. Clean and dry wheel surface before installing decal.
2. Locate bottom of dial decal 1/16" from 1/8" dia. hole
on face of gage wheel.
Figure 2-39. Capacity indicator Dial
– JLG Lift – 3120863