Place; Security Notes; Cleaning; Disconnecting The Line Cord(S) From The Phone - Topcom DESKMASTER 510i User Manual

Place

For the placement of your phone, please ensure:
• Do not place the phone in an area where it may come into contact with water and chem-
icals.
• Plastic support pads of the phone:
The equipment has been manufactured for usage in normal environments. Chemical
influences from the area, in which you place the phone (chemicals used for the mainte-
nance of furniture) may have an impact on the plastic pads. This may then result in
unwanted damage to the furniture surface.
In the environment of new or refreshed furniture, we therefore suggest you to place the
phone on a nonskid mat (cloth etc.).
• Hands free speaking:
The hands free facility enables communication with the handset on hook. Other persons
in the room may then participate in the phone call. In order to achieve best hands free
quality, please mind the following:
The environment of the phone should not be covered by subjects such as piles of paper,
coffee pots etc.
It is suggested to ensure a free area of at least 15 cm at the front right part of the phone.

Security Notes

The ISDN Deskmaster has been manufactured in accordance with EN60950 :1992. The
adaptor supplied with the analog port version is also in accordance with EN60950.
The plug may only be operated at 230V mains supply. Please verify that the isolation of the
adaptor is neither damaged nor defective.
Attention
During operation, dangerous voltages may be generated in the phone. Do not
try to open the phone. The phone contains no parts, which could be repaired
by the customer. The supplier does not assume any liability for usages outside
the warranty and safety regulations.
2
Deskmaster

Cleaning

The phone can be cleaned without any problem. Please ensure the following:
• Wipe the phone with a damp cloth or use antistatic material.
• Never use a dry cloth for cleaning.
(Static electricity may lead to electronic defects.)
Please take care that no liquid gets inside the equipment (switches and contacts may be
damaged).

Disconnecting the Line Cord(s) from the Phone

• Press the lock towards the plug.
• Simultaneously pull the plug at the cord out of the telephone.
Note
The same procedure is also applicable for the analog port cable.
Deskmaster
3