Indicator Leds; Linking Process - echoflex OWS Installation Manual

Wall switch sensor

Table of Contents

Indicator LED's

Three LEDs (red, yellow and green) are located behind the PIR lens of the

sensor.

During normal operation the red LED will blink when the sensor is sending an

occupied telegram.

The LEDs are also used during the selection of the test modes and to indicate

status information.

See the Test Mode section for more details.

The linking process requires the controller or receiver to be mounted, powered

and within range of the OWS to be linked. Each Echoflex controller can support

up to 20 linked devices. Linking the OWS occupancy sensor and the OWS switch

will consume 2 of the receivers available linked devices. The controllers blink

code will indicate the number and type of objects linked and can be checked to

confirm the linking process completed successfully (Consult the manufacturer's

controller/receiver install guide for more information).

Linking the Wireless Switch

1. Place the receiver into LEARN mode by pressing the Learn button on the

receiver. Consult the manufacturers directions if needed.

2. Quickly click the top side of the switch rocker 3 times.

3. Deactivate LEARN mode at the receiver. Test operation of the switch by

switching ON and OFF.

Note: Repeating these steps will UN-Learn the switch from the controller.

Linking the Wireless Occupancy Sensor

1. Remove the OWS faceplate.

2. Place the receiver into LEARN mode by pressing the Learn button on the

receiver. Consult the manufacturers directions if needed.

3. Tap the Teach button (right of the PIR lens).

4. Deactivate LEARN mode at the receiver.

Note: Repeating these steps will UN-Learn the sensor from the controller.

Table of Contents