Table of Contents
Advertisement
Installing the NAM into a Multislot Housing
The illustration shows the 14-slot access carrier housing.
CAUTION:
Be sure that you install the NAM in the correct slot so that it mates with its
matching I/O card. Otherwise, you could damage your card.
Procedure
1. Remove the NAM from the shipping
box. Handle only by the top and
bottom edges to avoid damaging the
card.
2. At the front of the carrier, align the
NAM with the upper and lower tracks
of the appropriate slot.
3. Slide the NAM into the tracks until it
seats with the midplane connectors.
Use care not to force the card or
bend any pins.
4. Close the carrier's upper and lower
ejector latches to lock the card into
place, then tighten the captive
screws on the ejector latches.
5. Check that the OK LED lights.
If the OK LED is on, you have power.
If not, refer to Troubleshooting in the
iMarc SLV Operations Guide for possible explanations.
Ejector
Latches
5
Front View
98-16209
Advertisement
Table of Contents
