Table of Contents
Advertisement
There are two methods for installing and setting up the iMarc unit.
„
One person can install and set up the unit. If this is the case, see Full Installation
and Setup.
„
An installer can physically install and set up access to the unit, and the network
operation center (NOC) can complete the setup. If this is the case, see
Installation for Service Providers
Certain procedures are common to both the full installation and minimal methods. These
procedures are referenced in the full and minimal installation instructions (starting with
Setting Up Local Management at the Central Site
needed.
Full Installation and Setup
An Easy Install screen is provided to simplify installation and setup. It can be used for
the first part of the installation when one person is installing and setting up the unit from
beginning to end.
Easy Install Screen Example
main/easy_install
Device Name: Node A
Service Type
Node IP Address:
Node Subnet Mask:
TS Access:
Create a Dedicated Network Management Link
Ethernet Port Options Screen *
Time Slot Assignment Screen
Network 1 Line Framing Format:
Network 1 Line Build Out (LBO):
Network 1 Line Coding Format:
-----------------------------------------------------------------------------
Ctrl-a to access these functions, ESC for previous menu
Save
on page 14.
EASY INSTALL
DLCI
11
on page 16). Refer to them, as
Frame Relay
000.000.000.000
000.000.000.000
980
ESF
0.0
B8ZS
MainMenu
Minimal
9128-II
12/18/2002 23:32
Clear
Clear
Exit
Advertisement
Table of Contents
