Table of Contents
Advertisement
Minimal Installation for Service Providers
In the following procedures, once the unit is installed and minimal configuration is
completed using the Easy Install feature, the NOC can complete and verify the setup.
Physically Installing the Unit and Setting Up for Remote Access
It is assumed that frame relay service is turned on at the site.
Procedure
1. Follow Steps 1 through 8 of Full Installation and Setup on page 8.
2. If the DSX-1 interface will be used, install the DSX-1 cable (see
on page 24).
3. Install the modem cable (see
4. If the unit is equipped with an ISDN DBM, install the ISDN DBM cable (see
Connecting to ISDN
5. If you will use the Ethernet port for management, install the Ethernet cable (see
Connecting to Ethernet
6. Install the DTE cables (see
Physical installation of the unit is complete; the NOC can now remotely access the unit
for additional configuration.
Connecting the Modem
on page 24).
on page 25).
Connecting to a DTE
on page 24).
on page 25).
14
Connecting to DSX
Advertisement
Table of Contents
