Connecting to an M66 Block
Use the optional T1 mass termination cable to connect up to seven NAMs to an M66
block. The T1 mass termination cable is a 5-foot RJ48H cable consisting of a 50-pin
plug-to-seven RJ48C plugs.
Procedure
1. Insert RJ48C plugs
on the RJ48H
network cable into up
to seven iMarc unit
NET interface(s).
2. Insert the 50-pin plug
end of the cable into
the M66 block.
3. Follow Steps 3 and 4
in
Connecting to the
Network
on page 21
to verify the
connection.
Plug Number
RJ48C
Plugs
22
M66 Block
Label
NAMs
50-Pin Plug
00-16837