Table of Contents
Advertisement
11. Set up SNMP local management (see
Site
on page 16).
12. Set up the modem, and the Call Directories if trap dial-out is desired (see
Up the Modem
13. If the unit is equipped with an ISDN DBM, set up the DBM (see
DBM
on page 19).
14. If SNMP traps are wanted, set up managers, select the desired traps, and configure
trap dial-out if desired (see
page 21).
15. Save the configurations.
16. Verify the entire path from the remote unit to the NMS is functioning (see
the End-to-End Path
17. If the DSX-1 interface will be used, install the DSX-1 cable (see
on page 24). Time slots for the DSX-1 interface will need to be assigned to the
network interface (see Assigning DSX-1 Time Slots to the Network Interface in the
iMarc SLV Configuration Reference).
18. Install the modem cable (see
19. If the unit is equipped with an ISDN DBM, install the ISDN DBM cable (see
Connecting to ISDN
20. If you will use the Ethernet port for management, install the Ethernet cable (see
Connecting to Ethernet
21. Install the DTE cables (see
22. Verify that data is being received (see
page 27).
23. Verify that all PVCs, including Management PVCs, are configured; and see whether
the PVC is active or not (see
24. Verify the setup for backup, if applicable (see
Data Can Be Passed Between DBMs
The iMarc installation is complete.
on page 17).
Configuring SNMP Trap Managers and Trap Dial-Out
on page 23).
Connecting the Modem
on page 24).
on page 25).
Connecting to a DTE
Checking PVC Connections
Setting Up Local Management at the Central
on page 24).
on page 25).
Verifying That Data is Being Received
Verifying the ISDN Line and That
on page 29).
13
Setting
Setting Up the ISDN
Verifying
Connecting to DSX
on page 28).
on
on
Advertisement
Table of Contents
