Table of Contents
Advertisement
Removing the NAM from a Multislot Housing
The illustration shows the 14-slot access carrier as the housing.
1. Unscrew the captive screws from the
ejector latches on front of the carrier.
2. Press open the ejector latches to
disengage the card.
3. Supporting the card by its edges,
pull straight out until the card clears
the carrier.
4. Lay the NAM on an electrostatic
discharge-protective work surface,
component side up, with the card
connectors on the left-hand side.
Proceed to Removing a DBM on page 5 if transferring a DBM to another NAM or
replacing a DBM. Otherwise, proceed to Installing a DBM on page 6.
Ejector
Latches
4
Front View
98-16209
Advertisement
Table of Contents
