Load Information; Led Indcations; Power-Up; Status Led - Morningstar EC-10 Installation, Operation And Maintanance Manual

CAUTION: Equipment Damage.
Excessive over-charging and gasing too
vigorously can damage the battery plates
and cause shedding of active material from
the plates. An equalization that is
too high, or too long, can be damaging.
Review the requirements for the particular
battery being used in your system.
Equalization (EQ) charging raises the battery voltage
above the standard absorption voltage so that the
electrolyte gases.

4.2 Load Information

CAUTION: Do not wire an AC inverter of any
size to the load terminals of the EcoPulse
- damage to the load control circuit may result.
Wire inverters directly to the battery or battery
bank.
4.3 LED Indications
KEY:
G = green G - Y - R = flashing sequentially
Y = yellow G / Y
R = red G / Y - R = G and Y flashing together,

4.3.1 Power-up

Normal power-up: Status LED flashes G, then SOC
LEDS flash G - Y - R, then SOC LEDs indicate battery
charge status with a single battery status LED.
22
Operation
= flashing together
alternating with R flash
Failed bootload: Status LED flashes G, then SOC LEDS
flash G - Y and stop on solid Y.

4.3.2 Status LED

Table 4.1 below lists the Status LED indications.
Color Indication
None Off (with heartbeat)
On Solid
Green
( with heartbeat)
Red Flashing
On Solid
Red
( with heartbeat )
Table 4.1. Status LED Definitions

4.3.3 State-of-Charge LEDs

Battery SOC LED Indications are shown in Table 4.2
below:
Condition
Absorption
Float
Equalize
Low voltage disconnect warning
Low voltage disconnect
Table 4.2. Battery SOC LED Indications
EcoPulse Operator's Manual
Operating State
Night
Charging
Error
Critical Error
Indication
G flash - every sec
G flash - every 2 secs
G flash - 2 / sec
R flash - every sec
R solid
23