Connecting The Power Cord (1) - Pioneer AppRadio SPH-DA100 Installation Manual

Section
Connecting the system
02

Connecting the power cord (1)

Depending on the vehicle type,
the function of *2 and *4 may be
different. In this case, be sure to
connect *1 to *4 and *3 to *2 as
shown in the figure.
ISO connector
Note
In some vehicles, the ISO connector may be
divided into two. In this case, be sure to
connect to both connectors.
8
Engb
Note
*2 *1
*4 *3
Yellow (*1)
Yellow (*2)
To terminal supplied with power
Back-up
regardless of ignition switch position.
(or accessory)
Red (*4) Red (*3)
Accessory To electric terminal controlled by
(or back-up) ignition switch (12 V DC) ON/OFF.
Orange/white
To lighting switch terminal.
Black (earth)
To vehicle (metal) body.
Notes
• When a subwoofer (*5) is connected to this
product instead of a rear speaker, change
the rear output setting in the initial setting.
(Refer to the Operation Manual.) The sub-
woofer output of this product is monaural.
When using a subwoofer of 70 W (2 Ω), be
•
sure to connect with the violet and violet/
black leads of this product. Do not connect
anything with the green and green/black
leads.
Connect leads of the same colour to
each other.
Speaker leads
Front left 
White:
White/black: Front left 
Front right 
Grey:
Front right 
Grey/black:
Rear left  or Subwoofer  (*5)
Green:
Green/black: Rear left  or Subwoofer  (*5)
Rear right  or Subwoofer  (*5)
Violet:
Violet/black: Rear right  or Subwoofer  (*5)