AEMC 8505 Quick Start Manual page 7

4. With the probe and clip separated, press the TEST button in the
center of the Model 8505 front panel.
The red OPEN light should blink while the button is depressed.
Release the button.
5. Connect the alligator clip to the probe tip, and press the TEST button
again. The red SHORT light should blink while you hold down the
button.
6. Separate the probe from the clip. Insert the tip of the probe into the
terminal labeled SELF TEST (T), and then press the TEST button.
The green Transformer (T) PASS light should blink, and the buzzer
should emit a steady sound.
7. Insert the probe into the terminal labeled SELF TEST (C), and press
TEST. The green Capacitor (C) PASS light should blink, and the
buzzer should sound.
If any of the preceding tests fail to produce the response described
above, return the instrument to AEMC
Quick Tester Model 8505
for repair.
®
7