Programming The Disc Tracks; Erasing The Programme - Philips FW C255 User Manual

Notes:
– During programme play or shuffling mode, it is
not possible to repeat playback the current disc
(Repeat Disc mode).
– Pressing the OPEN/CLOSE button will cancel all
repeat and shuffling modes.

Programming the disc tracks

Programming tracks is possible when playback is
stopped. Up to 40 tracks can be stored in the
memory in any order.
1
Load the desired discs on the disc tray (refer to
"Loading discs").
2
Press PROGRAM to start programming.
starts flashing.
PROG
3
Press CD 1/2/3 to select a disc.
4
Press í or ë repeatedly to select the desired
track.
5
Press PROGRAM to store the track.
¶ Repeat steps 3–5 to store other discs and
tracks.
6
To end programming, press Ç once .
stays and the programme mode
PROG
remains active.
The total number of tracks programmed and
the total playing time are displayed.
7
To start programme play, pressÉ Å .
"PLAY PROGRAM" is displayed.
Notes:
– If the total playing time is more than "99:59"
or if one of the programmed tracks has a number
greater than 30, then "--:--" is displayed
instead of the total playing time.
– If you attempt to programme more than 40
tracks, "FULL" is displayed.
– During programming, if no button is pressed
within 20 seconds, the system will exit the
programme mode automatically.
pg 001-028_255_21-Eng
To review the programme
Stop playback and press í or ë repeatedly.
To exit review mode, press Ç.

Erasing the programme

Press Ç once when playback is stopped or
twice during playback.
PROG
is displayed.
Note:
– The programme will be erased when the system
is disconnected from the power supply or when the
disc tray is opened.
For Recording, please refer to "Tape
Operation/Recording".
17
CD Operation
disappears and "PROGRAM CLEARED"
3139 115 21251
12/24/01, 10:56 AM
17