Table of Contents
Advertisement
Disc Operations
Programming the disc tracks
Programming tracks is possible when playback is
stopped. Up to 99 tracks can be stored in the
memory in any order.
IMPORTANT!
It is only possible to program from the
current selected disc tray.
1
5 D I S C D I R E C T P L AY
DISC 1
DISC 2
DISC 3
DISC 4
DISC 5
DISC 2
DISC 1
POWER
DISC 3
DISC 2
ON/OFF
DISC 3
DISC 4
DISC 1
DISC 4
DISC 5
DISC 5
CD / CD-R / CD-RW COMPATIBLE
1
Load the desired discs on the disc trays (refer
to "Loading discs").
2
Press CD or one of the DISC 1~5 buttons
to select a disc.
3
Press PROGRAM (PROG) to start
programming.
starts flashing.
PROG
4
Press í or ë repeatedly to select the
desired track.
For MP3 disc, press à / á (ALBUM 43)
and í / ë (TITLE -+) to select the
desired album and title for programming.
5
Press PROGRAM (PROG) to store.
Repeat steps 4–5 to select other tracks.
If you attempt to program more than 99
tracks, "PROGRAM FULL" is displayed.
6
To start program play, press É Å .
7
To stop playback or to end the programming,
press Ç once.
stays and the program mode remains
PROG
active.
20
2
4
6
OPEN/
CLOSE
7
1
2
3
3
4
5
3
5
,
Notes:
– If the total playing time reached 100 minutes or
if one of the programmed tracks has a number
greater than 30, then "-- : --" is displayed instead
of the total playing time.
– The system will exit programming mode if no
button is pressed within 20 seconds.
Checking the program
1
Stop playback and press í or ë repeatedly.
2
Press Ç to exit.
OR
Press ÉÅ to start playback from the
current programmed track
Clearing the program
Stop playback, then press Ç to clear the
program.
OR
Press the OPEN/CLOSE 0 button of the
disc tray.
disappears and "PROGRAM CLEARED"
PROG
is displayed.
Note:
– The program will be erased if the system is
disconnected from the power supply or you switch
to other source mode.
Advertisement
Table of Contents
