Table of Contents
Advertisement
Disc Playback
a disc is loaded in the disc tray
the current selected disc tray is empty
the current selected disc tray is loaded
the disc tray is currently playing
To play all discs on the disc trays
Press PLAYÉ (É Å ).
All the available discs will play once, then stop.
During playback, the selected disc tray, track
number and elapsed playing time of the current
track will appear on the display.
To play one disc only
Press one of the CD DIRECT 1/2/3 buttons
on the remote control.
The selected disc will play once, then stop.
To interrupt playback
Press PAUSEÅ (É Å ).
The current track time flashing.
To resume playback, press PLAYÉ (É Å )
again.
To stop playback
Press Ç.
To search for a particular passage during
playback
Press and hold à or á and release it when
the desired passage is located.
During searching, the volume will be reduced.
To select a desired track
Press í or ë repeatedly until the desired
track appears on the display.
If playback is stopped, press PLAYÉ (É Å ) to
start playback.
Note:
– In Shuffle mode, pressingí will cause the
player to skip only to the beginning of the current
track.
CD Operation
To skip to the beginning of the current
track during playback
Press í once.
To replace disc during playback
You are able to replace or load in disc into the
other two disc trays without interrupting current
playback.
While playback, press the CD OPEN•CLOSE
button of the inactive disc tray (refer to "Loading
Disc").
If you press CD OPEN•CLOSE button of
the active disc tray, the disc will stop playing and
the disc tray will slide out.
Once the disc tray is opened, it will be
deselected.
Programming the disc tracks
Programming tracks is possible when playback is
stopped. Up to 40 tracks can be stored in the
memory in any order.
1
Load the desired discs on the disc trays (refer to
"Loading Disc").
2
Press PROG to start programming.
will start flashing.
PROGRAM
3
Press CD 1•2•3 or CD DIRECT 1/2/3 button
to select a disc.
4
Press í or ë repeatedly to select the desired
track.
5
Press PROG to store the track.
¶ Repeat steps 3–5 to store other discs and
tracks.
6
Press PLAYÉ (É Å ) to start programme
playback.
"PLAY PROGRAM" will be displayed.
To end programming without starting playback,
press Ç once .
The total number of tracks programmed and
the total playing time will appear on the display.
17
Advertisement
Table of Contents
Troubleshooting
