Disc Playback; Programming The Disc Tracks - Philips FW-C870 User Manual

Disc Playback

To playback all discs on the disc tray
Press PLAYÉ Å .
All the available discs will playback once, then
stop.
During playback, the selected disc tray, track
number and elapsed playing time of the current
track will appear on the display.
To playback one disc only
Press the DISC DIRECT PLAY button : DISC 1,
DISC 2 or DISC 3.
The selected disc will playback once, then
stop.
To interrupt playback
Press PAUSEÉ Å .
To resume playback, press PLAYÉ Å again.
To stop playback
Press Ç.
To search for a particular passage during
playback
Press and hold à or á and release it when
the desired passage is located.
During searching, the volume will be reduced.
To select a desired track
Press í or ë repeatedly (or Digits 0–9 on
the remote control) until the desired track
appears on the display.
If playback is stopped, press PLAYÉ Å to start
playback.
Note:
– In Shuffle mode, pressing í will cause the
player to skip only to the beginning of the current
track.
To skip to the beginning of the current
track during playback
Press í once.
pg 001-028/C870/21-Eng
Replace discs during playback
1
Press DISC CHANGE.
2
To change the inner disc, press DISC
CHANGE again.
"DISC CHANGE" will be displayed and the
disc will stop playing.
The disc tray will close to retrieve the inner
disc, then reopen with the inner disc accessible.

Programming the disc tracks

Programming tracks is possible when playback is
stopped. Up to 40 tracks can be stored in the
memory in any order.
1
Load the desired discs on the disc tray (refer to
"Loading Discs").
2
Press PROG to start programming.
PROGRAM
3
Press CD (CD 1•2•3) or DISC 1/2/3 button
to select a disc.
4
Press í or ë (or Digits 0–9 on the remote
control) to select the desired track.
5
Press PROG to store the track.
Repeat steps 3–5 to store other discs and
tracks.
6
Press PLAYÉ Å to start programme playback.
"PLAY PROGRAM" will be displayed.
To end programming without starting playback,
pressÇ once .
The total number of tracks programmed and
the total playing time will appear on the display.
Notes:
– If the total playing time is more than "99:59"
or if one of the programmed tracks has a number
greater than 30, then "--:--" will appear on the
display instead of the total playing time.
– If you attempt to programme more than 40
tracks, "PROGRAM FULL" will be displayed.
– If you press any of the DISC DIRECT PLAY
buttons, the system will playback the selected disc
or track, and the stored programme will be ignored
temporarily. The
disappear temporarily from the display. It will
reappear when playback of the selected disc ends.
– During programming, if no button is pressed
within 20 seconds, the system will exit the
Programme mode automatically.
17
CD Operation
will start flashing.
symbol also will
PROGRAM
3139 115 20404
6/8/01, 8:32 AM
17