Programming The Disc Tracks; Erasing The Program - Philips FW- FW-C399 User Manual

Programming the disc tracks

Programming tracks is possible when playback is
stopped. Up to 40 tracks can be stored in the
memory in any order.
1
Load the desired discs on the disc tray (refer to
"Loading discs").
2
Press PROGRAM to start programming.
starts flashing.
PROG
3
Press CD or DISC 1/2/3 to select a disc.
4
Press í or ë repeatedly to select the desired
track.
5
Press PROGRAM to store the track.
Repeat steps 3–5 to store other discs and
tracks.
6
To end programming, press Ç once .
stays and the program mode remains
PROG
active.
The total number of tracks programmed and
the total playing time are displayed.
7
To start program play, pressÉ Å .
"PLAY PROGRAM" is displayed.
Notes:
– If the total playing time is more than "99:59"
or if one of the programmed tracks has a number
greater than 30, then "--:--" is displayed
instead of the total playing time.
– If you attempt to program more than 40 tracks,
"FULL" is displayed.
– If you press any of the CD DIRECT 1/2/3
buttons on the remote control, the system will play
the selected disc or track, and the stored
programme will be ignored temporarily. The
symbol also will disappear temporarily from the
display. It will reappear when playback of the
selected disc ends.
– During programming, if no button is pressed
within 20 seconds, the system will exit the program
mode automatically.
pg 001-031/C399/37-Eng
PROG
19
CD Operation
To review the program
Stop playback and press í or ë repeatedly.
To exit review mode, press Ç.

Erasing the program

Press Ç once when playback is stopped or
twice during playback.
disappears and "PROGRAM CLEARED"
PROG
is displayed.
Note:
– The program will be erased when the system is
disconnected from the power supply or when the
disc tray is opened.
For Recording, please refer to "Tape
Operation/Recording".
11/28/01, 1:34 PM
19
3139 115 21071