Safe Start; Valet Modes; Valet Mode Using The Valet Switch; Home Valet Tm " Mode - Autostart AS-1735 User Manual

option, one will not be able to start your vehicle with the key unless the system has been unlocked
and disarmed first, or put into Valet Mode.
Note: If the Starter Kill is installed, your vehicle will benefit from a protection against starter
motor damage that could occur after remote-starting the engine should the user, by force of
habit, turn the ignition key to the

Safe Start

If this feature is enabled, the user must press the
start the vehicle. This will eliminate accidental remote starts, e.g. when children are playing with the
transmitter.
If Swap Start Mode is selected, to remote-start your vehicle press
simultaneously. The

Valet Modes

Valet Mode Using the Valet Switch

When your vehicle is in Valet Mode, the remote starter functionalities are disabled. If the vehicle
needs to be serviced, or if you park it indoors, the Valet Mode will prevent the engine from being
remote-started accidentally.
To put the system i n t o Valet Mode:
1. Turn the ignition key to the
2. Within 3 sec., press the valet button. The parking lights will flash 3 times.
3. Turn the ignition key to the
The L.E.D. will come
To take the system o u t o f Valet Mode:
1. Turn the ignition key to the
2. Within 3 sec., press and release the valet button.
The parking lights will flash twice and the L.E.D. will come
now out of valet mode.
Note: Once Valet Mode is activated, the remote starter will be disabled.
"Home Valet TM " Mode
If configured at installation, this feature will remotely set the vehicle to a no-remote-start mode: if
the vehicle is parked indoors there is no danger of it starting accidentally by remote control.
Note: Once the Home Valet Mode is activated, the vehicle will not start by
To take the system i n t o Home Valet Mode:
• Press the
• Within 3 seconds, press the
To take the system o u t o f Home Valet Mode:
• Turn the ignition key to the
The system will warn you if someone attempts to start your vehicle while it stands in Home Valet
Mode. The parking lights will:
• Go
then
ON
• Flash twice, pause; then
• Flash twice again.

Turbo Mode

If Turbo Mode is configured at installation, it will allow a turbocharger to idle down after the user
leaves the vehicle: the unit will take over the vehicle and keep it running for 60 seconds (or until it
is shut down by remote control), then shut down the engine.
P. 8
CRANK
output can be activated by pressing the
AUX 2
IGNITION ON (RUN)
IGNITION OFF
solid indicating that the vehicle is now in valet mode.
ON
IGNITION ON (RUN)
or button.
LOCK UNLOCK
AUX
IGNITION ON (RUN)
; then
OFF
position.
button 2 times within 3 seconds to remote-
START
position.
position.
position.
button until the Parking Lights go out
position.
LOCK
button.
START
indicating that the vehicle is
OUT,
remote.
and
UNLOCK
User Guide