Audio Offset; Prog Channels; Operations Menu - Analog Mode; Ch / Frequency Menu - RF Central RFX-RMR Operator's Manual

9.5.11 Audio offset

The analog audio outputs from RFX-RMR Receiver are designed to feed into a 600Ω input
impedance.
If the receiver is connected to a higher impedance load, the output level will be ~6dB high. This can be
compensated for by using the 'audio offset' function.
Note: This does not change the output impedance from 600Ω.

9.5.12 Prog Channels

Each of the ten frequency channels can be independently allocated the required frequency in 0.5MHz
steps.
The ▲▼ buttons are used to select the Channel to be assigned. The Enter button then allows the
▲▼ to edit the required frequency, The A and B buttons move cursor left/right. The Enter button then
stores the value and returns to the Main menu.
9.6 Operations Menu – Analog mode

9.6.1 Ch / Frequency Menu

This menu is not available when the receiver is in "switches" control mode.
The menu is the same as the digital menu as mentioned in clause 9.4.1.
9.6.2

Rx mode

This menu is not available when the receiver is in "switches" control mode.
The menu used is the same as the digital menu as mentioned in clause 9.4.2.
9.7 Engineering Menu – Analog mode
The Engineering menu provides the method of system configuration; there are no user adjustments or
setups internal to the Rx.
The engineering menu is entered by pressing the "C" and 'E' buttons simultaneously for 2 to 10
seconds, then releasing the 'C' button.

9.7.1 "Switches and Key-pad" Control Mode

The menu used is the same as the digital menu as mentioned in clause 9.5.1
9.7.2

SW Inventory

The menu used is the same as the digital menu mentioned in clause 9.5.2, expect the values relate to
RFX-RMR Issue 1.0
41
page 30 of