The Transmitting Equipment; Transmitter / Receiver Tests - RF Central RFX-RMR Operator's Manual

10.2 The Transmitting Equipment

The RFX-RMR may be used with a variety of RF Central analog and digital transmitters including:
RMT, digital/analog transmitter
CMT Clip-On transmitter
Full details of the operation of the transmitters is given in the associated manual
Check that audio, video, and DC cables of sufficient total length and are in good condition.
extension cables are necessary ensure that the connectors are compatible and of good quality to
avoid problems at site.
Check that the receiving antenna / Receiver interfaces are clean and free from dust and other
unwanted materials.
If tripods are to be used to mount the equipment, make sure that some means of securing the tripod or
of weighting it down is provided. Gusty wind conditions may put installations at risk, particularly when
parabolic antenna dishes are to be used.
Make sure that all batteries to be used are fully charged and, whenever possible, provide a spare with
cable to connect it to the receiver.
Check that the receiver channel frequencies are compatible with those of the RFX-RMR transmitter
and set the channel selector switch to the channel number required. The receiver is labeled with
channel number and frequency information.

10.3 Transmitter / Receiver tests

Whenever practical, set up the system and trial it before leaving for site to ensure that all
components of the system are working. Checking at base, where adjustments and corrective
actions can be made, will pay off when setting up at site.
RFX-RMR Issue 1.0
If
41
page 38 of