Table of Contents
Advertisement
9.5
Engineering Menu – Digital receiving mode
The Engineering menu provides the method of system configuration; there are no user adjustments or
setups internal to the Rx.
The engineering menu is entered by pressing the 'Cancel' and 'Enter' buttons simultaneously for 2 to
10 seconds, and then selecting the 'Enter' button.
9.5.1 "Switches and Key-pad" Control Mode
The RFX-RMR may be configured such that the selection of channel frequency and operating mode
(analog or digital) is selected from the keypad menu or via the two front-panel rocker switches.
The ▲▼ buttons and Enter are used to select the required sub menu. Then choose "key-pad" or
"Switches"
9.5.2
SW Inventory
The versions for all software used in the receiver can be obtained from this menu. This may be useful
in communicating with RF Central factory regarding any future software upgrades which may become
available.
9.5.3
Channel Plan
The RFX-RMR Receiver can be switched between two different sets of 10 preset RF frequencies
known as the 'Old' BAS channel plan and the 'New' BAS channel plan.
The ▲▼ buttons are used to select the channel plan menu. The Enter button then allows the ▲▼
buttons to select the required plan. The Enter button then stores the plan which is then used by either
the front panel channel select switches or the keypad operation selection menu mentioned in section
9.4.1
9.5.4
Video Format
The video format may be selected PAL or NTSC
The Enter button allows the ▲▼ buttons to select the required value. The Enter button then stores the
value and returns to the Main menu.
9.5.5 Video Output Configuration
The Receiver provides two analog video output BNC connectors that can be configured to provide two
CVBS (Composite) outputs or a single YC component output.
Title
CVBS
YC
RFX-RMR
Note
Two composite outputs
Issue 1.0
Output
CVBS on both Bancs
Y on BNC 'CVBS/Y'
C on BNC 'CVBS/C'
page 28 of
41
Hide quick links:
Advertisement
Table of Contents
