NEC SL2100 Programming Manual page 121

SL2100 PC Programming Manual
To make a connection between PCPro and the system:
1. Select a Connection Type and specify the settings relevant to the
selected type.
❍
TIP
2. Specify the User Name and Password used to allow the connection.
3. Alternatively, steps 1~2 can be skipped loading a defined connection
account (refer to
4. Press the Connect button.
After a successful connection, the connection settings that are used are
set to the File Properties.
2.2.1 Connection Types
PCPro supports three types of connections to a SL2100 system.
Connection Types for SL2100:
IP

An IP Connection can be made via a LAN or the Internet. The IP
address specified should match the system setting 10-12-01. If
connecting to the Ethernet port on the VoIP daughter board, use the
IP address setting in 10-12-09.
Dial-up

An IP Connection via Dial-up can be made via a dial-up connection,
either through ISDN or an analog modem.
NOTE
Outbound IP

Use this setting along with the IP connection if the listen port number
needs to be changed to match the destination system configuration
The listen port number should match the value of 90-54-02 on the
system. And the IP address of the PC should match the value of
10-12-01 or 10-12-09.
If connecting to an SL2100 system, select either IP or IP via
Dial-up or Outbound IP.
- Connection Accounts).
Modem connections require an EXIFB mounted to the
❍
CCPU. The inbound trunk can be DID to the modem
access (PRG 11-15-14 Default 740) or can go through the
auto attendant with an option pointed at 740.
To configure a dial up connection, refer to section
❍
Create SL2100 Dial Up Connection on page
Issue 1.0
2.2.2
B-4.
B-3